| Model | 50PLS2.15S, 50PLS2.4S, 50PLS2.75S |
|---|
Back to products
Next product
Tsurumi PNI
$400.00 – $500.00
Tsurumi PLS
$280.00 – $580.00
Horizontal Resin-made Pumps with Vortex Impeller
The PLS-series is a submersible horizontal semi-vortex pump designed for handling wastewater and liquid carrying small solid matters. It is made of resin and 304 stainless steel and is excellent in corrosion-resistance. Because of the horizontal design, the continuous running water level is lower than conventional vertical types, and it can be used in a shallow or narrow sump.
Liquid paraffin is used for the lubricating oil, which widens the application of the pump to decorative waterfalls, fishponds, aquaculture, etc.
Model Selection:
| Discharge Bore (mm) | 50 |
| Motor Output(kW) | 0.15 – 0.75 |
| Discharge Bore (mm) |
Model | Motor Output (kW) |
Phase | Starting Method |
Solids Passage (mm) |
| 50 | 50PLS2.15S | 0.15 | 1-phase | Capacitor Run | 38(10)* |
| 50 | 50PLS2.4S | 0.4 | 1-phase | Capacitor Run | 24(10)* |
| 50 | 50PLS2.75S | 0.75 | 1-phase | Capacitor Run | 24(10)* |
* Figure in ( ) shows the solids passage of the pump with a strainer. The Strainer is supplied as a standard accessory.
Additional information
Related products
Tsurumi PNI
Resin-made Pumps with Vortex Impeller
The PNI-series is a submersible semi-vortex pump designed for handling wastewater and liquid carrying small solid matters. It is made of resin and 304 stainless steel and excellent in corrosion-resistance. The semi-vortex pump design with moderate solids passage provides efficient performance for versatile applications. Liquid paraffin is used for the lubricating oil, which widens the application of the pump to decorative waterfalls, fishponds, aquaculture, etc.Model Selection:
| Discharge Bore (mm) | 50 |
| Motor Output(kW) | 0.4 - 0.75 |
| Discharge Bore (mm) | Model | Motor Output (kW) | Phase | Starting Method | Solids Passage (mm) |
| 50 | 50PNI2.4S | 0.4 | Single | Capacitor Run | 10 |
| 50 | 50PNI2.75S | 0.75 | Single | Capacitor Run | 10 |
GEX e-AIR 1000SB
- Fits on aquarium with water depth below 35cm, and 45cm in width or less
- Discharge rate at approximately 800cc / minute
- Single Type
- Size: Dimension 78x50x125mm
- Weight 178g
Resun LP-60
The Resun Air Pump LP60 delivers with low noise a maximum air output of 4200L/hr (70 litres per minute), which is suitable for the vast majority of fish and koi ponds. It must be housed to be protected from dust ingestion. Dust will prematurely wear the rubber valves & diaphragms.
Installation hints:
- Do not install any brand of air pump of this size in the lounge room unless you like a continuous low noise hum whilst watching TV. Place the pump in a non-habitable room, or outside, and then plumb air line tubing to the tank diffusers.
- To increase the life of the rubber diaphragms, the unit must have back pressure. See details below.
- Electromagmetic linear diaphragm technology
- Low noise. Decibel levels measured in a quiet room using A-frequency weighting with medium back pressure loading on the pump: 41dB(A)+/- at 3m from air pump, 53dB(A)+/- at 500mm from air pump. A quite room ambient noise level is 30dB(A)+/-
- Cast aluminium body
- Voltage/Wattage: 240V / 60W
- Automatic thermal cut-out overload protection
- Cable length: 1.5m
- Max pressure: 0.037MPa
- Max air output: 4200L/hr (70 Litres/minute)
- Air pump outlet diameter: 20mm
- Must be set-up above the water level
- Important: Rated IPX4 (meaning - Should be placed in a low dust environment but will tolerate rain and light sprinkling)
- Maximum water depth for placed airstones or air diffuser: 3.5m
- Supplied with a plastic 14 outlet manifold to suit 4mm silicon air line
- Air Pump dimensions: 245mm(L) x 205mm(W) x 210mm(H)
- Weight: Air Pump, 5.45kg. Cartoned pump: 6.3kg
- As preventive maintenance, the industry standard would require that all linear electromagnetic air pumps running 24/7 should be dismantled, air jet cleaned & have the diaphragms & valves replaced every 18 months or 12,000 hours
- The pump must only be used in a dust free environment.
- The pump must only be run with a back pressure load. Do not use for long periods with unrestricted air flow. This will stretch the diaphragms to cause premature tearing or distortion. Back pressure is created by having the air diffusers or air stones deep in the water or if not possible, a flow control tap fitted into the air line.
ANS Check Valve
2pcs/pack
Check valve to stop water from flowing in the wrong direction and accidentally draining an aquarium in the event of an air pump failure.
- Keep air flowing in the right direction and stop water from flowing out of the tank
- Use the air check valve as a safety precaution whenever using air pumps
- Use with aquarium air line tubing and an air pump to allow air out and keep water from flowing back
- not suitable for Pressurized Co2 system
Onga Leisuretime Pool Pump
- The range of LeisureTime pool pumps have been purposefully designed to provide maximum performance and corrosion resistance at a realistic cost.
Features
- Self-aligning barrel unions
- Elevated motor foot
- Corrosion resistant endshield
- Large hair and lint pot with see through lid
- Low friction lint pot O-ring
Oase OptiMax 300 – 1000
- Proper movement: Ideal for efficient water circulation or for operating an aquarium filter
- Easy to adjust: The water flow rate can be easily adjusted
- Area of application: Only for use inside the aquarium and underwater
- Efficient: Particularly efficient water supply
- Compact design: The OptiMax 300 and 500 are particularly easy to conceal
- Practical: Two suction holders for mounting in place
| Model | OptiMax 300 | OptiMax 500 | OptiMax 800 | OptiMax 1000 |
| Dimensions (L x W x H) (mm) | 55 x 42 x 60 | 55 x 42 x 60 | 78 x 52 x 88 | 78 x 52 x 88 |
| Rated voltage | 230 V / 50 Hz | 230 V / 50 Hz | 230 V / 50 Hz | 230 V / 50 Hz |
| Power consumption (W) | 5 | 6 | 7 | 12 |
| Power cable length (m) | 1.50 | 1.5 | 1.5 | 1.5 |
| Net weight (kg) | 0.18 | 0.18 | 0.32 | 0.37 |
| Guarantee (Years) | 3 | 3 | 3 | 3 |
| Max. flow rate (l/h) | 300 | 500 | 800 | 1000 |
| Max. head height, metres (m) | 0.60 | 0.8 | 1 | 1.3 |
| Pressure-side connection (mm) | 13 | 13 | 17 | 17 |
| Suction-side connection (mm) | 13 | 0.5 | 17 | 17 |
| Suitable for freshwater | Yes | Yes | Yes | Yes |
| Suitable for saltwater | Yes | Yes | Yes | Yes |
Resun AC-9902
- Twin outlet air pump
- Maximum output 4.0 ltr/min (240 ltr/hour)
- Maximum depth of the aquarium 21"
- Modern design with vibration absorbing feet
- Suitable for aquariums up to 180 ltr (40 gallon) and ponds up to 800 ltr
SUNSUN JGP-2500L
Features:
- Â The shell is made of high quality reinforced ABS and durable.
- It adopts high-strength wear-resistant shaft core, which is resistant to acid and alkali and corrosion.
- Suitable for low water levels.
- Suitable for aquariums.
| Model | JGP-2500L |
| Rated power supply | 110V/220V/240V |
| Rated Frequency | 50Hz/60Hz |
| Rated Power | 40W |
| Maximum Lift | 2.3m |
| Maximum Flow | 2500L/h |
| Outlet (mm) | 12, 16, 20 |
| Power Cord Length | 2.5m |
| Weight | 0.9kg |
| Dimension | 135x105x152mm |
Reviews
There are no reviews yet.